Household Automatic Balanced Door is the new Automatic Door type developed by Ningbo Gdoor automatic door R&D group. The operating mode of Household Balanced Door is totally different from Automatic Sliding Doors. Household balanced door operator drives two door leaves till door leaves keep parallel with walls, which enhances space and achieve optimization. Imported door hardwares and self-developed balance door spare parts are installed on the household balanced door operator. Automatic Balanced Door for household is suitable for study,parlor room, etc.. Household Automatic Balanced Door Household Automatic Balanced Door,Household Balanced Door,Automatic Doors,Household Automatic Door Ningbo Gdoor System Control Technology Co., Ltd. , http://www.gdoor-cn.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>Automotive bearing device, application and protection knowledge Automotive bearing equipment, application and protection knowledge
An important difference between a car and a general mechanical bearing is that the car bearing is used in a moving environment; thus its force and working conditions are more and more chaotic; together with the car as a very fine mechanical part; the correct device and application, Smoothness and protection are essential for completing the basic functions of catching. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
The bearing assembly and disassembly are cleaned with clean kerosene or gasoline to clean the bearings and associated parts.
Check whether the bearings that are ready for use can match the original type;
Use a special device to press the bearing into the sleeve; the diameter of the east and west sleeves should not exceed the outer diameter of the bearing ribs; the force should be evenly distributed in the device; do not impact and rough equipment,
After the bearing device is finished, the bearing and associated components should be rotated; check for stuck images and abnormal noise.
Write the specified smooth grease or smooth oil as required by the main unit components.
When the large bearing and the bearing between the bearing and the shaft and the seat hole are large, it is necessary to heat the bearing in the oil bath; the oil temperature is about 80 degrees Celsius.
When the bearing is disassembled; it is necessary to use special things for drawing; it is strictly forbidden to directly hit the bearing with iron.
When the bearing device is disassembled; it should be prevented from being stressed or deformed by the rolling body and the cage.
Recommend to friends comments close window Bearing related knowledge Thrust angle touch ball bearing rolling bearing completes vibration reduction and noise reduction progress life bearing diagnosis
The characteristics and application of fag bearing on the tube mill using bimetal bearings and JBD
This article links to http://
Please indicate the bearing network http://
Previous: Knowledge of Rolling Bearings--- Bearing Acquisition Knowledge Next: The Division of Bearing Seal Layout
Automotive bearing equipment, application and protection knowledge
Source: China Bearing Network Time: 2017-11-07