First, the stone binder construction method: 1. Base treatment: remove all kinds of unfavorable substances such as grease, floating dust and loose material on the surface of the adhesive layer. The bottom layer and the facing material do not need to be wetted with water, and the bonding surface of the facing material should be kept clean; 2. Preparation of adhesive glue. Mix the binder: water in a ratio of about 4:1 (weight ratio) and stir to a slurry of appropriate consistency. Allow to stand for 10 minutes. During this time, the consistency of the mixture will increase and stir well. It can be used until it is restored to its original consistency. In the second mixing, it is generally unnecessary to add water. 3. Pasting method: Apply the glue to the base surface with a trowel or a toothed scraper, and press or sway the tile and other decorative materials on the glue, or mix the glue according to the conventional sticking method. The slurry is applied to the back of the tile, and then pressed to the wall, squared, and scraped off the excess glue. 4. Jointly after 24 hours. Second, the precautions when using stone adhesive: 1. The water used to mix the binder must use clean water (eg clean tap water); 2. During the process of preparing the adhesive, no other materials or additives should be added; 3. The adjusted slurry should be controlled to be used within 2 hours; 4, the bonding surface of the stone should not be treated with ordinary protective agent before bonding, otherwise it will cause it to fall off; it is recommended to use AD2009 waterproof adhesive, which can prevent falling off and waterproof stain, Baihua. 5, the construction temperature can not be lower than 5 ° C, winter can be properly heated to increase the surface temperature. 6. When there are chemical substances or oil stains on the surface of the stone, it should be cleaned and kept dry. 7, the glue is now used, the amount of glue should not be too much; if the temperature is low, the amount of glue is small, the use time and curing time is long; conversely, the curing time is short. 8. Do not mix the glue taking tools. Do not put the remaining glue after mixing into the original package. Do not move the board when the glue is not fully cured. 9. In winter, if the viscosity of the glue is large, the glue (A) can be placed in a 40-80 ° C water bath to reduce the viscosity, but after heating, it must be cooled to below 40 degrees and then the curing agent (B) can be added. 10. Extrusion of excess glue after surface coating, can continue to be used on other stones before uncured. 11. Due to the physical and chemical properties of the stone, please try it in advance to avoid mistakes. Do not cover the lid, use the back cover tightly, do not enter! 12. The principle of how much to use when advocating glue is recommended. It is now available and must be used up within the available time. The more the amount of ingredients or the higher the construction temperature, the shorter the usable time.
Dish Rack,dish drying rack,kitchen dish rack,dish drainer rack,dish rack sink,etc. The materials used are 304 stainless steel, easy to clean, never rust!
China Kichen Rack,Sink Grid,Stainless Mesh Storage Baskets,Kitchen Wire Storage, we offered that you can trust. Welcome to do business with us.
Kichen Rack is made of high quality 304 stainless steel, This kind of material steel luxury, never rust, resist corruption, easily clean, safe, healthy and durable. Prevent rust or chemicals from contaminating food and damaging health
kitchen dish rack,dish drainer rack,dish rack sink,Kitchen drying rack,Stainless steel drying rack Shenzhen Lanejoy Technology Co.,LTD , https://www.copper-nut.com