To this end, the relevant information was consulted and it was decided to change the material of the rubber block to polyurethane. Polydecyl ester has many properties with high elasticity over the entire hardness range, good flexibility over a wide temperature range, good oil and grease resistance, and high Young's modulus compared to rubber of the same hardness. . In March 2000, polyurethane rubber blocks were installed on the side couplings of the No. 5 cement kiln double drive system for comparative tests. The result of the test was that the rubber block was cut after one month, and the polyurethane block was still in normal use. In view of the success of the No. 5 kiln test, we also promoted the polyurethane block to the 2.6, 3, 1 cement mill coupling, the vibration of the reducer was reduced, the noise was also significantly reduced, and the operation effect was very good. This year alone reduces maintenance and spare parts costs by more than 100,000 yuan. Editing Wang Yanli's manual spiral gate improvement Ouyi Honghua Run Cement Factory, Dongguan 523990, Guangdong, China Manual spiral gate adopted a practice of 1. Remove the upper part is not good to enter or exit, or close the place, causing the missing material. Moreover, the greater the pressure of the insert plate, the tighter the contact with the lower support side, and the sealing effect is exerted. In addition, due to the absence of pressure on the upper part, the material is easily shoveled by the inserting board and moves freely. Editor Wang Yanli inserts silo discharge port under the support of China Institute of Ceramics Environmental Protection Branch held a new technology lecture and consultation meeting on cement dust collection. The cement plant of the China Silicate Society Environmental Protection Branch and the Anzhen Building Materials Industry Association The dust new technology lecture and consultation meeting was held on June 46, 2001 in Jixi County, Anzhen Province. At the meeting, Vice Chairman of the Tianjin Cement Design and Research Institute Wang Zujie introduced the development and prospects of the dust collection technology of Yongni Plant. The application of high-concentration electric precipitator, wet tower in cement plant, and kiln charging The design points of the dust collector are described. Secretary Mao Zhiwei gave a lot of examples to explain the application trend of the dust collector in the cement plant. Comrade Wang Cong of Wuhan Anhuan Institute of Atmospheric Institute introduced the application of bag low-pressure pulse bag dust collection technology in the renovation of clinker grinding system in cement plant. Comrade Li Wei, the leader of the expert group, described the use of new technology to transform low-efficiency bag dust collectors. The countermeasures include replacing the filter material with high gas-to-cloth ratio; more, cleaning the dust, improving the cleaning quality; increasing the filtration area, reducing the filtration wind speed; and replacing various new Accessories. Executive Director Chen Huanqi introduced the new control power supply high-frequency high-voltage power supply control object of the international electric precipitator, which is much smaller than the existing power supply, saves 80, and can adapt to the high specific resistance dust of =51012; It does not produce anti-corona, it is a promising control device. Li Zai Shi Gaogong discussed the development and challenges of the turtle dust collector. The most active factor of electric dust removal is the plate line configuration. As long as the reasonable plate line configuration is developed and a reasonable rapping system is adopted, the selection can be reduced. Weight, improve efficiency. For the dust collection of the Qianfa kiln, the humidification tower is used for quenching and tempering, and the nozzle with uniform atomization and long service life can be used to solve the high-efficiency dust collection of high specific resistance dust, and the desulfurization rate can reach 50. There are only two measures to solve the high-concentration electric dust collector in foreign countries, that is, the mechanical pre-collection dust and ash hopper are smooth and airtight. We are fully capable of solving it. Do not introduce introduction and re-introduction, and pay attention to the invention and creation of technology. The current international hotspots related to electric precipitators are switching power supplies; airflow distribution. The upper part of the distribution plate has a high flow point of 1; it solves the rapping of the secondary dust; The representatives also conducted discussions and exchanges on relevant questions. Jiao Yongdao Ground Screw For Solar Power System is applied in fixation of solar panel. Pole anchor and Earth Anchor are fit for outdoor as the spiral pile mounting system adopts special materials that can resist corrosion, like HDG (hot dip galvanizing) and anodized silver15μm, screw pole mount system is adaptable for different soils. Additionally, it is easy to install. After it is removed, the vegetation can soon recover to reduce harm to surroundings. Ground Screw For Solar Power System Ground Screw For Solar Power System,Ground Mount Solar Foundations,Solar Ground Screws,Ground Screw Anchor Hebei Honde Plastic & Metal Co., Ltd. , https://www.foundation-system.com
Advantages:
1. Simple installation
There is no need to do welding or surface treatment, which saves time and cost. You just need to drill. Generally speaking, it just takes one day to install one screw pole mount system with 100-200 ground screws.
2. Large-scale application scope The screw pole mount system is suitable for different soils, like soft soil, bed rock, swamp and slope with more than 30°..
3. Spiral pile mounting system can work together with different support structures. The Ground Screw can be made according to client`s requirements.
4. Adaptable for different environment and environmental-friendly
There is no need to do much preparation for installation and there is no harm to environment during installation. Besides, ground screw can protect PV equipment and can be recycled.
5. Convenient transformation
Screw pole mount system can be transformed easily without damage to vegetations. Additionally, it is simple to reinstall.
the advantages of ground-screws for mounting solar photovoltaic systems
-Usually less invasive and landscape-altering than traditional mounting systems such as the half A-frames that are typically installed on cement slabs
-Screws can be easily adjusted to less serious gradients so mounting-frames are installed level: less complicated earthwork and engineering involved as compared to cement slabs
-More aesthetically pleasing than a cement mounting platform: shade-tolerant grasses and plants can easily grown beneath them