The installation of the shower room has become a fashion, dry and wet separation is also very beneficial for bathroom ware, reducing the erosion of water vapor, mothers no longer have to worry about the sanitary ware damp. At the same time, the installation steps of the shower room can also effectively reduce the frequency of explosions in the shower room. It is necessary to create a safe, reliable and comfortable home, and you can do more with less. 1. Install the bottom basin of the shower room. First of all, it is necessary to combine the parts of the bottom basin to determine the level of the bottom basin, to ensure that there is no water in the basin, the tube should be stretched with the distance, and then the bottom of the basin and the floor drain. The connection is firm. If the bottom basin is not used, the water strip in the shower room is to be affixed to the floor tiles when tiling. The reason for this is to have good water repellency. 2. Test and protection: After installation, water test should be carried out to ensure unimpeded flow. Find and punch: Use a pencil and a level to determine the drilling position of the aluminum against the wall and punch the hole with a hammer drill. 3. Install aluminum: Knock on the rubber in the hole and lock the aluminum bar to the wall with screws. 4. Fix the glass: Lock the glass to the hole in the bottom basin and fix it with screws. 5. Install the top tube: find the corresponding position drill hole above the fixed glass, install the (straight/oblique) fixed seat and connect the top tube. Secure it to the top of the glass with a bent sleeve. 6, the installation rack: the position of the installation of sanitary ware 7. Install the movable door: Install the hardware of the movable door and install the hinge on the reserved hole of the fixed door. After installation, adjust the position of the shaft of the lotus leaf until the door feels the best. 8. Make waterproof: Install the suction strip or water retaining strip on the side or below the glass as required. Use aluminum mesh to seal the seam between the aluminum and the wall, glass and bottom basin. 9. Commissioning and fastening: Check whether all parts are comfortable and smooth, and find problems in time. After adjusting, tighten the corresponding screws to make the whole shower room firmer. 10. Finishing work: The decorative aluminum strip is stuck into the wall-mounted aluminum material to ensure that the appearance is neat and generous. Finally, wipe the entire bathroom with a rag.
The Infrared Heater is made from carbon crystal which is a atom status of carbon. This heater is very efficiency, the electric - heat transfer rate is more than 95%. And because of this, the Infrared Panel Heater can save more than a half energy than air conditioner. Also this Panel Heater is much better than the wind-blowing type heater which makes people feel dry.
Dexiang infrared heater is the No.1 famous brand in China. The quality of Dexiang is strongly good, which easily can allow the panels a 5 years warranty and normally a 50 years long working life.
Our heaters are CE, ETL, ISO certified, we welcome all friend to be our dealers based on mutual benefits !
Infrared Heater Infrared Heater,Far Infrared Heater,Infrared Electric Panel Heater,Infrared Painting Heater Shandong Dexiang Electrical Technology Co.,Ltd , https://www.infraredroomheater.com